Soil sample digestion is an important sample preparation step in elemental analysis and environmental testing. Soil matrices can contain complex mineral components and different chemical substances, making effective acid digestion essential for preparing samples for subsequent analysis.
In this experiment, a Welso WMD600 Microwave Digestion System was used to digest soil samples through a programmed combination of nitric acid and hydrochloric acid, followed by a perchloric acid treatment. The following procedure records the sample preparation process, digestion parameters, and observed results.
1. Experimental Materials and Equipment
Sample: Soil, 0.1 g
Reagents:
Nitric acid (HNO₃): 5 mL
Hydrochloric acid (HCl): 3 mL
Perchloric acid (HClO₄): 1 mL

Equipment:
Welso WMD600 Microwave Digestion System

10 mL pipette
Acid evaporation equipment
2. Soil Sample Digestion Procedure
Step 1. Sample Preparation
Accurately weigh 0.1 g of soil sample and transfer it into the microwave digestion vessel. Add 5 mL of nitric acid and 3 mL of hydrochloric acid. Allow the mixture to stand for approximately 10 minutes to ensure sufficient contact between the sample and digestion reagents.
Step 2. Microwave Digestion
Seal the digestion vessel, mix the contents thoroughly, and place it into the WMD600 microwave digestion system. Run the programmed digestion procedure according to the following temperature and pressure settings.
Pressure (bar) | Temperature (°C) | Power (W) | Ramp Time (s) | Hold Time (s) |
20 | 100 | 1000 | 200 | 200 |
30 | 180 | 1000 | 120 | 200 |
40 | 220 | 1000 | 120 | 3600 |
The multi-stage program gradually increases the digestion temperature and pressure, allowing the soil sample to undergo the programmed acid digestion process.

Step 3. Acid Evaporation Treatment
After the microwave digestion cycle is completed and the vessel has cooled sufficiently, carefully open the digestion vessel. The resulting solution shows a gray precipitate.
Transfer the solution to an appropriate acid-resistant evaporation vessel. Add 1 mL of perchloric acid and heat at 180°C for approximately 20 minutes using an appropriate acid evaporation system.
3. Experimental Observations
After the digestion and subsequent heating treatment, a small amount of turbidity was observed at the bottom of the solution.
This observation was recorded as part of the experiment. Further sample processing and analytical verification may be required depending on the intended elemental analysis method.
4. Why Use the Welso WMD600 for Soil Digestion?
Soil digestion requires controlled heating and pressure conditions to handle complex sample matrices. The Welso WMD600 supports programmable multi-stage digestion, allowing users to configure temperature, pressure, microwave power, and holding time according to different sample preparation requirements.
During this experiment, the system's real-time temperature and pressure monitoring helped track the digestion process at each stage. Its 360° vessel scanning design monitors individual digestion vessels, while adjustable microwave power supports different digestion programs.
The WMD600 also allows users to save customized digestion methods for future use, making it practical for laboratories that regularly process environmental and soil samples.

5. Conclusion
This experiment demonstrates the use of the Welso WMD600 Microwave Digestion System for soil sample preparation using a staged nitric acid and hydrochloric acid digestion procedure, followed by perchloric acid treatment.
The programmable digestion process provides a controlled approach to soil sample preparation. The observed residual turbidity also highlights the importance of evaluating the final solution according to the requirements of the subsequent analytical method.
Follow official account